|Alert Message||ModSecurity: Access denied with code 400. Too many threads|
This rule is triggered when a a single IP has opened too many connections to the apache webserver in a READ state. This condition is unusual for a normal client, and occurs when either an attacker is trying to use up all the threads on the server to prevent it from servicing any other clients (Denial of Service Attack) or if a single IP needs to open an unusually high number of READ connections.
This alert will also occur when a slowloris attack is occurring.
This rule reports when apache has stopped accepting READ requests from a client. You can configure this limit by following the Tuning Guidance below.
[warn] ModSecurity: Access denied with code 400. Too many threads  of 10 allowed in READ state from 184.108.40.206 - Possible DoS Consumption Attack [Rejected
The rule alerts when the configured WAF_READSTATELIMIT value is exceeded. The rule does not cause this event to occur, it just reports when it occurs.
Disabling this rule will not prevent this event from occurring, it will just prevent ASL from alerting you that this is occurring.
We do not recommend you disable this rule. If you do not wish to shun on this rule, just change the Rules configuration for Active Response to "no". See below for tuning guidance if the default READ state limit is too low for your system.
This limit is configured by this setting:
Increasing this limit may make your system vulnerable to slowloris attacks. Setting this too low may cause legitimate clients from being able to connect to your system.
Knowledge Base Articles
The default limit in ASL3 is 10, the default limit in ASL4 is 100. ASL4 contains additional safeguards against Denial of Service attacks and can safely allow a higher limit without a decrease in protection.