Unattended installs
Contents |
Introduction
ASL 4 supports unattended installations. That means you can use the configuration of one system as the template for a new system. The installer will not ask questions for options that are templated. This document explains how to do an unattended installation.
Important Note
ASL 4 contains a number of new features that are set up on Installation. While you can also configure these features from the ASL web console after its installed, it may be easier to perform a full guided installation once if you have other servers to install. This will save you time needed to enable these new features on the other systems.
Step 1 : Copy the configuration file to the system
From a system with ASL already installed, copy this file:
/etc/asl/config
To the system you want to install ASL on, or upgrade, in this file:
/root/asl.cfg
Note: You can do this on the same system if you want a totally unattended upgrade of an existing ASL system to occur.
Step 2 : go to the root users directory
On the new system, without ASL installed:
cd /root/
Step 3 : run the installer
Run the installer as you normally would as the root on the system with the file /root/asl.cfg
wget -q -O - https://www.atomicorp.com/installers/asl |sh
Input will only be required if:
- The installer encounters an unresolvable error
- A major change is detected
Step 4 : optional for upgrades
Note: This is only required for unattended upgrades. If you are doing an unattended install on a new system, you do not need to run this step.
Once the installation is complete, you must re-install the ASL database. Run this command as root:
/var/asl/bin/database-setup
